A faucet can look like the right choice online and still leave you with a handle that hits the backsplash or a spout that barely reaches the bowl. If you’re updating a bathroom in Virginia’s Northern Neck, make these three checks while you can still change your faucet, sink, or vanity top selection.
1. Count the holes and measure their spacing
If you’re keeping the sink or countertop, photograph the existing faucet from above. When the mounting holes are visible, measure from the center of one outside hole to the center of the other. A trim plate can hide extra holes, so ask your remodeler to confirm the layout if you can’t see it. Kohler’s faucet guide shows common configurations, including three-hole centerset faucets with a 4-inch spread and widespread models with more room between the handles. Check the exact model’s specification sheet before ordering.
2. Check where the spout will land
Compare the spout reach on the drawing with the distance from the mounting hole to the inside of the bowl. Leave enough room to wash your hands comfortably. If you’re choosing a vessel sink that sits above the countertop, compare the spout height with the height of the rim as well. For a new vanity top, have the faucet and sink selections confirmed before the holes are drilled.
3. Leave room for the handle to move
Look at the space behind the faucet, especially if the vanity has a raised backsplash. Check the handle’s full range of motion on the drawing or a display model. Once you’ve narrowed down the models that fit, you can compare finishes and look for EPA WaterSense-labeled bathroom faucets if water efficiency is a priority.
Bring an overhead photo, your measurements, and any model numbers to the estimate conversation. If a vanity update is part of a larger bathroom project, you can contact AMC Remodels to discuss the scope and request an estimate.